|
| |
COMMON QUESTIONS AND ANSWERS.
Q: The Actuator seems to be frozen or too stiff?
A: The Actuator pressure is directly related to the amount of lift required for your boat. Larger
 heavier boats require more lift at the stern. The plate and actuator pressure need to be sized to
fit your boat. Make the adjustment as shown on pages 8 to 10 in the installation manual , and
they will work properly.
Q: The boat is not as fast as it was before using SMART TABS?
A: There are two probable causes which require a simple adjustment.
1. Before installing SMART TABS you may have the motor "Trimmed" into the transom so that
the boat planed quicker. This is no longer necessary, and should be changed so that the
motor is straight up and down. You regain the speed and improve efficiency.
2. SMART TABS may be incorrectly adjusted with too much pressure. Refer to pages 8 to 10 in the installation manual , and reduce the pressure.
Q: The boat does not plane any better with SMART TABS?
A: If the correct model has been chosen increase the lift pressure (refer to pages 8 to 10 in the
installation manual ). If increasing the pressure does not give satisfactory results, call customer
service for assistance.
Q: How do I keep the SMART TABS up for beaching, tailoring, or placement on chalks?
A: Refer to page #9 for Storage and Beaching instructions in the installation manual .
Q: The boat is unstable at high speeds?
A: On fast boats this is called chine walking. The boat is running on a very small part of the hull. Increasing the lift pressure will permit SMART TABS to resist the side to side movement and
stabilize the boat.
|
|
|
8080 Snowville Rd.